Network

 

You must complete all the network data before you can add any new element or busbar.

 

Choose ( Network  > View > Elements data ) to see the network elements table and you can get full data about each element by double click on it.

 

Choose ( Network  > View > Buss ) to see the network busbars table and you can get full data about each busbar by double click on it.

 

If the third column ( Used ) in busbars table not equal to 1 this means this busbar not connected to any element so you will not be able to solve any problem in this network before you connect any element to this busbar.

 

If you want to delete any element change the element type to a switch and open it.

 

If you want to delete any busbar connect it to only one element (a switch and then open it ).

 

You must close the opened network before you can create new network or load a saved one.

 

 

 

Short Circuit

 

You must choose ( Network > Calculation ) to generate Z bus before you can solve a short circuit problem .

 

 

 

Circuit Drawer

 

Choose the draw resolution ( Draw Network > Resolution  > ) ( Low , Medium or High ) “depends on you system resources”.

 

You can get full data about each element by double click on it.

 

 

 

Impedance Scan

 

After the calculations completed choose the draw resolution ( Draw Curve > Resolution  > ) ( Low , Medium or High ) “depends on you system resources”.

 

Transmission Lines

 

Capacitors

 

Filters

 

Cables